Hi eightsecmopar, I also own an 88 Bullet in Switzerland. I like your new seats and upholstery. Where did you get these, please?

Thanks....They were done by Mick's custom upholstery in Missouri.
Post some pictures of your Bullet, would like to see it.

Hi Wayne, what's your speeds, drives and prop selection with these 570hp?

I believe Waynes boat runs high 70's almost 80. I had a Bullet that ran 80 with 575 a side. Bravo drives with Bravo1 28pitch lab finished props

I am very interested in this also. whats the fastest bravo and TRS bullet?

Casey's old blue bullet with the blower motors in it by Brad Smith ran very well low 80's.

We tried with 28pitch lab finished props, Bravo 1 drive, +590hp and couldn't get more than 4500-4600 rpm. That made around 68 mph... We now limited the rpm's to 4200 for running the engine in only. It does good 60mph with 4000 rpm. Next week we will change to 26pitch lab finished Bravo 1 (4 blades) and see what happens... On the dyno we had these 590 - 600 hp with around 5200-5300 rpm. So, the prob is definitely to big to get these hp's comming up. I'll keep you updated... Cheers!

I think your elevation definitely had something to do with your outcome.

Sorry haven't posted sooner, been using the camper alot this summer and built a new garage (never used the boat once and full of fuel, now I have to winterize it) The motors dynoed at 572hp (using a single 800 carb, 86/94 jets if I remember), I am running used B1 26p props (never had them labbed or checked) with a bravo 1.5. My WOT is 5000-5300 approx. (tachs started bouncing around at high rpm, put resistor plugs in this season but never ran the boat) I am running low to mid 70's as is. I have a pair of 420 blowers that I would like to swap out over the winter, but I also have to install the dog dishes in the hatch for clearance. No transom notch by the way.

there was a bravo bullet in jersey a few weeks ago.. what happened to it?