Bolsters
 

CHRISBB - What is your e-mail address? I will e-mail you pictures in the next couple of days. They are white and in good shape. I do not have the stands, I used them for the 3-man bolster.

Barry

OC Barry,

my e-mail is [email protected] or [email protected]

the stands are no problem.

thanks,

Chris

Hey Barry,

Nice to hear you're doing a 28! Is it/was it brown??
What power and drives?

I am basically on my 5th TRS drive(combination of #4's good upper, and #3's good lower) since 2003. I may finally go to a Konrad this winter, and may have a total of three drives available, (one good, two with blown lowers), along with gimble if you need anything.

I also have a 177 blower available, sitting on bench, as I have been NA since 2004.

Eddy

pics of the engines
 

These engines were supposed to get Dart 200cc heads. when they got to the engine builder he inspected them and found that 3 of the 4 had factory repairs. Dart wouldnt replace them or gaurantee the repairs and he ended up sending them all back. these engines are getting RHS heads.

Chris

Nice looking rig. IMO the boat looked great from the factory. I would have done the same keeping it original in appearance. I have a Tbred that looks great with factory graphics. Can't wait to see it in running in the water.Best of luck Bob.

Eddy - Please refresh my memory, your 27 Cigarette is my old boat, correct (the one I sold to Kenny Boss)? Yes. I'm apparently going through a cycle of offshore boats in this order: 28 Cigarette, 27 Cigarette, 34 Coyote; 38 Cigarette, 20 Cigarette (still have it), and now 28 Cigarette.

No, the boat has a black hull. I am installing new Bravo XR transom assemblies and new IMCO platinum XR's. Blown 355 Cubic inch small blocks (.0404 over) with WP heads, WISECO pistons, and Jesel rocker assemblies. We are building the boat for P4, so it should be a interesting ride.

My engine builder has a pair of good SSM4's if you are interested.

Send me your e-mail address and we'll talk off line about the 177 blower, I am interested.

Good to hear from you again, Barry

Barry, no, I bought another one - two of my friends looked at yours when Kenny sold it, I do believe. Haven't seen your old one since it sold back then, 5-6 years ago.

Any idea where I might get a set of the 56" SS side vents made??

I'll try to PM you.

Barry, you can e-mail me at [email protected]

Eddy