2000 TopGun Lip-Ship Resto
02-02-2009 | 08:39 PM
#81
Registered
Joined: Aug 2001
Posts: 14,576
Likes: 4,561
From: Channel Islands, So. Cal.
Just wanted to thank everyone for their input, I never expected such a big response.
Went down to see the boat Saturday and put together a deal with Phil this afternoon!
Since this is my first high performance boat I'll probably be on this forum quite a bit looking for advice.
Thanks again!
Went down to see the boat Saturday and put together a deal with Phil this afternoon!
Since this is my first high performance boat I'll probably be on this forum quite a bit looking for advice.
Thanks again!
5 people on board, 3/4 fuel...Not bad!
Hope to see some more pics when you get back down there to run again!
02-02-2009 | 09:04 PM
#83
VIP Member
Joined: Feb 2004
Posts: 12,314
Likes: 1,556
From: Maryland
Congrats Greg...it is a beauty.
Brad, everyone is going to have their own reasons why they like somone. Tres is extremely knowledgable and has given me some great advice that I will be trying on my tiger, his knowledge ranks up with the best. Martin offshore and then later Tres himself along with phil have taken a great product and been the gobetween between the owner and the factory and as Brandon said is the eyes of the customer during the build. i would be happy to own a boat that either of these two set up.
another example with boats could be a higher x dim, the factory has a standard for each model, and will make it. Phil and Tres with their knowledge, may go an inch higher with x dim for the customer to give a better top end, as they have tried it. hopes this helps
Brad, everyone is going to have their own reasons why they like somone. Tres is extremely knowledgable and has given me some great advice that I will be trying on my tiger, his knowledge ranks up with the best. Martin offshore and then later Tres himself along with phil have taken a great product and been the gobetween between the owner and the factory and as Brandon said is the eyes of the customer during the build. i would be happy to own a boat that either of these two set up.
another example with boats could be a higher x dim, the factory has a standard for each model, and will make it. Phil and Tres with their knowledge, may go an inch higher with x dim for the customer to give a better top end, as they have tried it. hopes this helps
02-02-2009 | 09:47 PM
#87
Thread Starter
Platinum Member
Joined: May 2003
Posts: 3,707
Likes: 89
From: MA and NH
Congratulations Greg!!! That is one great running boat. That's the one boat I wish I kept. Enjoy it and get used to all the onlookers and the attention that this boat will generate.
Last edited by pm203; 02-02-2009 at 09:50 PM.
02-03-2009 | 06:50 AM
#89
Registered
Joined: Oct 2003
Posts: 2,670
Likes: 13
From: Turkey Point Island Edgewater Md.
Just wanted to thank everyone for their input, I never expected such a big response.
Went down to see the boat Saturday and put together a deal with Phil this afternoon!
Since this is my first high performance boat I'll probably be on this forum quite a bit looking for advice.
Thanks again!
Went down to see the boat Saturday and put together a deal with Phil this afternoon!
Since this is my first high performance boat I'll probably be on this forum quite a bit looking for advice.
Thanks again!
Congrats Beautiful Boat!!!!!
02-03-2009 | 07:15 AM
#90
Registered
Joined: Oct 2005
Posts: 728
Likes: 3
From: Fort Worth, TX
When it comes to Cigarettes Yes to the first one and by far,very far and further then very far better then Tres's rigiging. LOL that funny that Tres even got compared in this.
