cabin door wheel
05-21-2012 | 08:19 PM
#1
Thread Starter
Registered
Joined: Jan 2006
Posts: 179
Likes: 2
From: brick nj
cabin door wheel
So I decided to clean the crap from behind the port side helm and snowball effect took place and now powder coating door tracks, aluminum, brackets etc. I NEED a new roller for the door slide. It is hard black plastic and very specific. I emailed Phil. I am wondering if anyine has one ? I will machine one if necessary, but doesn't hurt to ask !! Thx Boys ,Greg
05-21-2012 | 08:26 PM
#2
VIP Member
Joined: Mar 2004
Posts: 637
Likes: 114
From: East Coast
So I decided to clean the crap from behind the port side helm and snowball effect took place and now powder coating door tracks, aluminum, brackets etc. I NEED a new roller for the door slide. It is hard black plastic and very specific. I emailed Phil. I am wondering if anyine has one ? I will machine one if necessary, but doesn't hurt to ask !! Thx Boys ,Greg
05-25-2012 | 10:30 AM
#5
Registered
Joined: Nov 2004
Posts: 274
Likes: 1
From: Friendship ,MD
I had the same problem a couple of years back and i had a machine shop make one out of delrin. cost about 55 bucks for 2 of them.
also i think you can buy two tubes of delrin and slide one inside the other then cut to size.
also i think you can buy two tubes of delrin and slide one inside the other then cut to size.
