Bead Blasted all the old paint off the housings... Everything is re-cleaned and ready to assemble now!!




Forward Clutch Assembled!!* Earl Zimmer gave me all the specs needed to assemble his trans!! Earl is a class act and I can't say enough good things about him!! He is more concerned with getting your trans built right than making money off you!!* Thanks Again for everything Earl!!



Forward Clutch, Planetary and Reverse installed in the trans!



Checking trans endplay



Can't forget the trans bible!! IF anyone needs it I can email it to you in PDF....

Trans Assembled & Painted. Notice the new custom 12 point stainless bolts and nuts!! I used anodized pipe plug fittings and -12 Cooler Fittings for Stainless Lines. Also installed new breathers!!














Both Trans were rebuilt with all new clutch packs!

Forgot to post a picture of the control valve.... This has Huber's oil pressure modification done to it!! look for the washer hehe

Well that pretty much brings us up to today!!

Detailed the bilge, figured out what hoses need to be replaced etc.. Need to refinish the tops of my sea strainers too....

Lookin pretty sweet! Can you send me a 72C manual? I also had Earl do both my trannies, never met him, but was real easy to deal with over the phone.

2 things that make a good thread,,,, A good project with good pics. Very cool.

Hey, what transom assemblies are those? Konrad or cut down / trimmed off TRS assemblies?

I ask because I have a very similar set up and was thinking I could trim the "ears" off of the TRS plates since I am not using the switchable exhaust, I have the Konrads sitting in the box ready to bolt on.

great pics & commentary!

Those are SSM 3a's with the Konrad PRS III Conversion Drives on them.

post or pm your email and I will get the manual out to you!

Sent the manual to you... Check your email!