Cigarette Addiction
#24
Registered
Thread Starter
I believe it is a 43 BT....not sure of the owner. Vincent has turned about every screw on the boat other than engines and drives. I even had him rework the electric cabin door mechanicals to allow it to open / close smoother. He beefed up the factory mounts and realigned the threaded arm. I'm convinced that it is quieter and smoother than the day it left the factory. Doug at Mastertech helped with the drive setup changes and is finishing the wiring for the gauges. Other than that, I'm waiting to reinstall a steering ram that we replaced a seal kit in and swap out a MAP sensor. I'm quickly running out of things to finish!
#27
Gold Member
Gold Member
Here are a couple more that I snapped this morning. The removal of the chart holder on the navigator's station really cleaned that area up. The new switches go in tomorrow, then tie up any loose ends and hopefully back on the water by Thursday. Livorsi is shipping a couple more gauges that will need to be installed. Livorsi has been great to work with....less than a week turnaround time on custom gauges is top notch in my book. Vincent touched up a couple of rock chips from towing, then buffed the entire boat. I also fitted the new full cover this morning. It gets a little closer every day! [ATTACH=CONFIG]527362[/ATTACH][ATTACH=CONFIG]527363[/ATTACH][ATTACH=CONFIG]527364[/ATTACH][ATTACH=CONFIG]527365[/ATTACH]
Amazing Chad !!!! Look forward to speaking with you soon.
Chris