|
Originally Posted by payuppsucker
(Post 4275816)
My figure also included exhaust, used SM. My assy cost was only 5K but that included all ARP hardware and super dampners and other incidentals. I didn't see where I spent any money unnecessarily. If you're in at $25k for 650 per side you've done well IMO.
If I get the dominators now I should see 680+ |
I didn't take it like that at all. I was just saying....
|
Originally Posted by payuppsucker
(Post 4276007)
I didn't take it like that at all. I was just saying....
|
Mine did 674, 676 at 711, 715 ft lbs at 5800. That was with dominators on Reher Morrison adapters sitting on a 4150 flange intake, Bob M's recommendation. We built pretty much the same motors. How close are you to finishing them? My cams were a 7-2, 4-3, swap as well. No power diff but a smoother idle and supposed to be easier on internals.
|
Originally Posted by payuppsucker
(Post 4276036)
Mine did 674, 676 at 711, 715 ft lbs at 5800. That was with dominators on Reher Morrison adapters sitting on a 4150 flange intake, Bob M's recommendation. We built pretty much the same motors. How close are you to finishing them? My cams were a 7-2, 4-3, swap as well. No power diff but a smoother idle and supposed to be easier on internals.
|
He spec'd my entire build and I bought almost everything through him as well. I was well pleased with the results.
|
Originally Posted by payuppsucker
(Post 4276123)
He spec'd my entire build and I bought almost everything through him as well. I was well pleased with the results.
|
Lifters in..... timing chains in..... rockers in.... cams this week, maybe other set of heads this week.....
|
Nice...... I seen u had Easter at your place should have put the family to work on them motors. .lol
|
Ha haha NO!!
|
| All times are GMT -5. The time now is 05:36 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.