|
I had a chipped skag. .... cost me 6k this winter to fix
|
Originally Posted by Full Force
(Post 4607158)
Platform off, one drive off, other has studs soaking (been on for years) have tailpipes off... getnO2 bungs welded in ASAP and out back in and clean up exhaust rings and all that
|
Originally Posted by Rhythm and Blues
(Post 4607191)
Tim, what was the gimbal repair you were talking about?
|
Originally Posted by boatnt
(Post 4607352)
do you have a issue on the transom around the left /port exhaust tip area?
|
Good stuff Timmy. Started on mine yesterday, want to get all the stuff done before April!
|
Originally Posted by frickstyle
(Post 4607381)
Good stuff Timmy. Started on mine yesterday, want to get all the stuff done before April!
|
Spent all day Sat fighting to get gimble ring apart, then realized how bad it sucks to try to do tiller arm in the boat with engines in, decided since it’s soeedmaster to remove the transom assemblies and do off boat, will allow me to clean it up and paint better, new seals, and wet sand and buff transom...
she will I’ll be nice when done!! |
14 Attachment(s)
Few pics of the progress ...
|
Transom looks solid!
|
Little elbow grease and it will look good as new! I noticed you pulled the transom assembly without pulling the engines, is it possible to do on a bravo setup in a TG?
|
| All times are GMT -5. The time now is 04:44 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.