Cigarette Topgun
#1161
Registered
How much independent trim travel does that arrangement give your drives before a heim joint wants to bind on the washers? Only reason I ask is the V-hull set-ups on the Konrad site have the tie-bars perched on top of the mounting plate... your set-up looks cleaner, just asking about the possibility of binding/ breaking if one drive had to be fully trimmed out (ie. trailer mode) - or the like and the other was trimmed down....
#1162
Registered
Thread Starter
Yea just a mock up run. It has a lot of movement is was set up like this before good looking out though!!! Just excited to see parts going back on
The following users liked this post:
speicher lane (06-06-2023)
#1165
Registered
Tie bars are Clevis style (double jointed) just for that reason.
Last edited by cheech; 06-06-2023 at 08:35 PM.
#1167
Registered
#1169
Registered
Thread Starter
Been working on finishing up a few small projects. Also been spending weekends at the lake with the fam. Making some progress on the cig been slow tho lol
The following users liked this post:
Bfoodman (06-23-2023)
The following 3 users liked this post by division1: