![]() |
Originally Posted by Full Force
(Post 4679391)
Flowed heads the other day....
gained 37 CFM intake and 46 exhaust at .700 lift... not bad for a partial port |
https://cimg1.ibsrv.net/gimg/www.off...515d38bdc.jpeg Thinking of working them more later to get full potential when I do solid roller conversion and lower end builds few years from now, we think we can get some nice numbers out of heads I already own.. this was just a cleanup and didn’t cost much at all to do. |
Originally Posted by Full Force
(Post 4679391)
Flowed heads the other day....
gained 37 CFM intake and 46 exhaust at .700 lift... not bad for a partial port |
Originally Posted by frickstyle
(Post 4679508)
Dude, you're gonna go like a bazillion miles an hour now! I'm gonna start plumbing for nitrous so I can keep up with you!
|
Originally Posted by frickstyle
(Post 4679508)
Dude, you're gonna go like a bazillion miles an hour now! I'm gonna start plumbing for nitrous so I can keep up with you!
|
Originally Posted by J-Bonz
(Post 4679515)
LOL.... Tim, you finally back working on the boat? |
|
Originally Posted by Full Force
(Post 4679521)
yes, been so busy dealing with rental to sell and other stuff, becoming a grand dad in Aug, so lots happening here... got a lot done on boat today.... finish heads next week and start making progress...
Jr. |
Originally Posted by hogie roll
(Post 4679523)
|
Originally Posted by J-Bonz
(Post 4679525)
Grand dad???? Arnt we like the same age? I am just had another tird and your already on the next gen.... LOL. Congrats to the wifey and you...
Jr. |
| All times are GMT -5. The time now is 07:02 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.