Cigarette adventure (new transoM and #6 conversion)
#71
Registered
Cut the hatch in the middle of the uprights, add 2 inches and you will only need to paint the sides and inside of them. The top around the emblem will not be affected. With the angle of the sides it will only be slightly more vertical adding 2 inches.
#73
VIP Member
VIP Member
If custom was easy everyone would do it!!
Any idea how to order a new cig? hahahaha jkjk don't want to derail another great thread
Any idea how to order a new cig? hahahaha jkjk don't want to derail another great thread
The following users liked this post:
ICDEDPPL (11-02-2022)
The following 2 users liked this post by Ironmanwb:
hogie roll (11-07-2022), Knot 4 Me (11-03-2022)
#75
Registered
iTrader: (1)
High temp duct tape. Gorilla brand preferably. Get black to blend in.
#76
VIP Member
VIP Member
Flex seal is the obvious answer
#77
Registered
iTrader: (1)
#78
VIP Member
VIP Member
Well hell that's even easier! Black tape as you suggested and roll hahaha
The following users liked this post:
SB (11-02-2022)
#79
Registered
iTrader: (1)
Maybe I corrected you too fast.
Did you mean flex pipe ? And it autocorrected to flex seal ? Flex pipe would work too.
Did you mean flex pipe ? And it autocorrected to flex seal ? Flex pipe would work too.