I am pushing from the wall behind the seat in front of my engines. I don't have any room between the exhaust to fit anything between them. These are the only pics I have on my computer. I will be out at the shop tomorrow and can get better pics. The white box in the first pic is where the ram mounts.

Did you build that one piece hatch or did the panther come with it?

Do you know the open and closed dimensions of the ram?

My boat came with the hatch.
Fully extended the ram is 42" from center of the holes and retracted it is 24.5". Here is a new pic from today.

Hope you don't mind me asking why you want to go from two to one hatch?

I always liked the twin hatches and how it makes it easy to get to things in the back of the engine bays, just wondering why you are changing.

Great question! There are definitely pros and cons to either design. Most of my decision to go with a single hatch was purely esthetics!

I want a single hatch pad with the scarab beetle embroidered on it and didn't want a seam down the middle.

I want to install mirrors on the bottom side of the hatch to showcase the power plants.

I want to clean up the looks in general.

The current hatches were water logged anyway so it was time for a change.

You bring up some good points about getting to the back of the engines to work on them but I built a board that I use when I need to do this that lays over the top of the engine and allows me to access the transmission area.

If it turns out that I hate the single hatch then I will make new double hatches next winter! It has been a fun project making this one!!

Got you,

The beetle should look cool !

Has anybody ever played with the idea of hinging a single cover on both ends, and depending on which set of hinges are in, being able to lift the cover from either the front or the back. Seems I'm always taking my entire cover off to get to something in the rear of the boat.