Engine Build Finally Under Way!!

Reply Subscribe

Thread Tools

05-21-2011 | 07:37 AM

#41

87MagnumII

Thread Starter

Registered

Joined: Apr 2010

Posts: 897

Likes: 10

From: Daniels, WV

Quote:

Originally Posted by fkboatman

I hope for your sake, that is a roller cam in that motor. Non roller cam needs 1500 rpm break in for about 20 min. with a break in oil...... sounds good.

It's roller

05-21-2011 | 10:30 AM

#42

HaxbySpeed

Registered

Joined: Mar 2008

Posts: 1,181

Likes: 2

From: Vancouver BC

Sounds great Dave, turn your idle up a bit.

05-21-2011 | 10:46 AM

#43

87MagnumII

Thread Starter

Registered

Joined: Apr 2010

Posts: 897

Likes: 10

From: Daniels, WV

Quote:

Originally Posted by HaxbySpeed

Sounds great Dave, turn your idle up a bit.

It's idling about 850 on the hose. Where should it idle in the water?

05-21-2011 | 02:25 PM

#44

HaxbySpeed

Registered

Joined: Mar 2008

Posts: 1,181

Likes: 2

From: Vancouver BC

That's good, it sounded quite a bit lower in the vid. As long as your shift interrupt switch is adjusted properly it'll work fine. Have fun out there!

05-22-2011 | 06:56 PM

#45

87MagnumII

Thread Starter

Registered

Joined: Apr 2010

Posts: 897

Likes: 10

From: Daniels, WV

Had it on the water today and runs good. Acceleration is awesome!!! Didn't run it to hard because it's still fresh but I believe it's gonna be one stout small block.