thunderbolt iv ignition modual
 

any way to test a v6 14 ignnition modual,swaped out the v8 22 for more base timming put a blower on sbc wont go over 3000 rpm :poopoo:

fixx
 

make sure you have at leaste 7psi of fuel pressure before you blow it up..it will bang and pop at 3k if the fuel pressure is low..

fuel system up graded high volume pump and 1/2 hose id, no pops or bangs just wont run over 3000 rpm,??????

fixx
 

new or used superchargergot a boost gauge?

Keep in mind, the V6-14 module only gives about 10* of advance on a V8 engine.

used b&m142 5lbs boost on gauge

base timming set at 19* so all in would be at about 29* should be right in the ballpark, but dosent seem like the timming is advanceing after 2500 rps like it should

if you have a light on it and timing doesn't move while revving, module isn't advancing. very few die, but that is more than none...

fixx
 

142 with 5 lbs of boost @ 3000 rpms?

what cubic inch?? if your trying to put that blower on a 502 cid your going to need a bigger blower or wine that one up until it exploads..sorry i dont think timing is your problem..i thing your not moving enough air into the engine that it requires..even with a 250 blower your usually around 3psi with around a 3'' blower pully..

Says sbc fixall so I'm guessing a 350? You'll have to put a light o it to verify timing isn't advancing. Is it making 5 psi at 3000? That's a lot at low rpm. My 174 on a 454 didn't really make much until 4000 rpm