Post a pic tomorrow, can something like this be hooked up? I’ve used these on all kinds of applications.

yes and no. Pic of the current line and the fitting that would fit in it. I can’t find the fitting.

I am thinking for drilling and tapping the fuel rail where that whole is. Then thread a 90 into that to a -AN fitting. Then have someone take my fuel line and add the proper AN fitting to mate with it.

Eddie Young redid my VST rail and angle cut the rear rail then tapped for new lines
As posted in your other thread

Here take a look at this. Lots of good stuff in here.

Modifying a stock 454/502 mpi intake

I wonder if you could tap those holes as mentioned. But do something like this. Tap it to 3/8, 1/2 or whatever works. Insert these fittings as connectors.


Think I’d rather have an aftermarket fuel rail that fits that but hard to see. Note you need to look at your hp rating for hoses -6 for 550, -8 550-1k, -10 for 1k+

Does anyone know what the part number for the fuel line that has the brass block that attaches to the center of the fuel rail?

I just modded a fuel rail off a early 502 mag and its still at my shop, Il post pics later