|
Originally Posted by XT-Innovator
(Post 4257469)
I need the fiberglass tray from that 25 Outlaw if you want to sell it, or trade me if I make you a correct 33 motorlid skin in your choice of colors. Call my cell number 419-569-1984 Dave
|
Originally Posted by ivanfuego
(Post 4257523)
Hey Dave do you mean under the rear seat bench? If so it has speaker holes in it but its clean. Its in florida but I can probably get a picture tomorrow. I'm sure the skin I got will work fine by just extending a few inches, but it might look a bit funny when its done. So a new skin with to match won't hurt!
|
Originally Posted by ivanfuego
(Post 4256922)
Yes pm me your email or cell number and I'll send you pics.
|
3 Attachment(s)
Update!! Almost done....
[ATTACH=CONFIG]536442[/ATTACH] [ATTACH=CONFIG]536441[/ATTACH] [ATTACH=CONFIG]536443[/ATTACH] Ended up using "dry" marine plywood that a friend had at Marine store they use for transoms, etc. Figured it lasted this long, I also glassed most of it anyway for good measure. |
4 Attachment(s)
Done!!!!
[ATTACH=CONFIG]536481[/ATTACH][ATTACH=CONFIG]536480[/ATTACH][ATTACH=CONFIG]536482[/ATTACH] [ATTACH=CONFIG]536483[/ATTACH] Ok, well, most of my winter projects are done!! Both pivot pins and redoing the hatch. Now, all I have left is swapping amps and changing some seals on my trailer tires that are leaking after only 2 seasons on all new bearings. I posted all these pics as I could not find any pics or YouTube videos of this project. Hope it helps anyone thinking about doing it. Easy job, just time consuming.... But that's what I enjoy, rather than my hectic day job!! |
Great job
|
2 Attachment(s)
Success!!! Wife helped me put it back on boat and I used straps and a 2x4 to hold it up so I could get the screws back into the hinges!! Luckily, we finally had a small wind blowing today!
[ATTACH=CONFIG]537073[/ATTACH][ATTACH=CONFIG]537074[/ATTACH] Now I have to change amp and get new seals for trailer and start cleaning!!!! What will get the rust stains off the back of the engine compartment? I used to get rust runs from the old t nuts when water used to drain out the hatch. |
THE WORKS toilet bowl cleaner from Walmart for under $2.00 per bottle.
|
Thanks.. should have checked this earlier, just got back from there!
|
Mine needs the hinges done.....Hope I can get one more season out of it!
|
| All times are GMT -5. The time now is 10:41 AM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.