30 outlaw twin 600sci Port engine wont start? Help!
#11
Thread Starter
Registered
Joined: Sep 2008
Posts: 243
Likes: 0
From: Pittsburgh, PA
Yes i heard a click.. now it doesnt click at all.. Batteries fully charged. Not a kill switch.. Not hydro locked. I had it running a couple times by reving the right engine. wont let me do that anymore.
#13
Thread Starter
Registered
Joined: Sep 2008
Posts: 243
Likes: 0
From: Pittsburgh, PA
#14
Thread Starter
Registered
Joined: Sep 2008
Posts: 243
Likes: 0
From: Pittsburgh, PA
Forgot about this good point 33outlawsst, loose lanyards burned me a couple times at the ramp. Also sticks for the trans get "bumped" and engine wont start. Make sure your completely in neutral. Check the simple stuff, going for the more in depth stuff has always cost me time when it was an easy fix / brain fart.
If the lanyard was loose or off neither engine would start.
#19
Registered

Joined: May 2011
Posts: 576
Likes: 1
From: Varna, IL
Do you have batteries you can swap out to rule that out? Just because it shows 12 volts doesn't mean it's good. Dealt with that this spring on another guys boat. Switched batteries and fired right up after spending hours checking other stuff
#20
Registered

Joined: Aug 2014
Posts: 250
Likes: 37
From: MN
Find the slave solenoid check for voltage on one side with key on and both sides of it when hitting the start position, if it has voltage both sides when hitting the switch its good if not jump it and try.
If that is good then go to the starter. Grinding noise leads me to believe starter went bad or was going bad and hopefully you didn't do it long enough to screw up flywheel.
If that is good then go to the starter. Grinding noise leads me to believe starter went bad or was going bad and hopefully you didn't do it long enough to screw up flywheel.




