Extension box - 26ZX
02-25-2008 | 04:03 PM
#11
Registered
Joined: Dec 2006
Posts: 21
Likes: 0
Hi Bill
Thanks for your input - am having some stainless tabs built to a 30" length and full width. Will also be moving them closer to the pad, and also considering fitting an extension box at the same time. Watch this space!! Good luck on the dyno, and please keep this thread going with the figures you end up with.
Regards - Trevor
Thanks for your input - am having some stainless tabs built to a 30" length and full width. Will also be moving them closer to the pad, and also considering fitting an extension box at the same time. Watch this space!! Good luck on the dyno, and please keep this thread going with the figures you end up with.
Regards - Trevor
02-25-2008 | 04:24 PM
#12
Thread Starter
Registered
Joined: Jun 2004
Posts: 834
Likes: 2
From: Tennessee
Trevor,
Thanks for the reply. Let me know how your project unfolds. Please let me know if you get into the whole ext box concept. I would love to see some pics of your setup. You can pm me with an amail address if you like.
Bill
Thanks for the reply. Let me know how your project unfolds. Please let me know if you get into the whole ext box concept. I would love to see some pics of your setup. You can pm me with an amail address if you like.
Bill
