38ZR Updates
The following users liked this post:
IGetWet (10-20-2022)
#42
Registered
Thread Starter
The following users liked this post:
IGetWet (10-20-2022)
The following users liked this post:
IGetWet (10-29-2022)
#45
Registered
Thread Starter
Pretty dumb they used little finish nails to secure the middle of the cabin balsa floor. Sooner or later they’ll rust through. I used one solid sheet of marine ply and several tubes of epoxy. https://masepoxies.com/product/gluzilla-fast
The following users liked this post:
darinof (10-29-2022)
#47
I had a local guy do mine, Xact Customs. He did a great job, great to deal with. Marine mat cut one small piece slightly wrong and he was on them to replace it. $600 a sheet for two colors. Three colors I think was another $100 a sheet, then $50 to cut the Donzi logo out. Everything I did was able to be done out of three sheets.
Pretty dumb they used little finish nails to secure the middle of the cabin balsa floor. Sooner or later they’ll rust through. I used one solid sheet of marine ply and several tubes of epoxy. https://masepoxies.com/product/gluzilla-fast
Pretty dumb they used little finish nails to secure the middle of the cabin balsa floor. Sooner or later they’ll rust through. I used one solid sheet of marine ply and several tubes of epoxy. https://masepoxies.com/product/gluzilla-fast
The following users liked this post:
IGetWet (10-30-2022)
#48
Registered
Thread Starter
That’s what it’s all about. Great hulls, getting up there in age, but still have a lot of life in them. Main reason of this thread was to show other ZR owners what can be done.
Last edited by IGetWet; 10-30-2022 at 08:01 AM.
#50
Registered