Opinions Needed - Surface drive to outdrive re-rig
#11
Registered
Thread Starter
Yes, the Konrad solution does offer a higher power and torque capacity, but I would have to use the ACE system to work in my short bilge, which introduces the unknown performance of extension boxes on this hull. I've tossed out the idea of Merc's ITS as well for the same reason. Tired of being the guinea pig. Standard HP Transom Assemblies and XR uppers are on the way. After we mock-up the engine location we'll know what we need for lowers.
#15
Registered
Have you considered putting fins on the skegs? George Desmond did just that on the worlds fastest Donzi 18 which topped put Just over 120. The boat ran very flat and just could not get loose, he added a fin to the ADS6 with a slight downward angle it was night and day! Rik knows very well of the mod! The boat was featured on Riks site for several years!
Phil
Phil
#16
SeaRay Sundancer
Gold Member
Join Date: Nov 2005
Location: SW Missouri
Posts: 2,914
Likes: 0
Received 0 Likes
on
0 Posts
Have you considered putting fins on the skegs? George Desmond did just that on the worlds fastest Donzi 18 which topped put Just over 120. The boat ran very flat and just could not get loose, he added a fin to the ADS6 with a slight downward angle it was night and day! Rik knows very well of the mod! The boat was featured on Riks site for several years!
Phil
Phil
Thread
Thread Starter
Forum
Replies
Last Post
thayes11
General Q & A
0
10-02-2005 12:36 PM