new progress on 2500 hp 2 speed transmissions
 

finally have the first two off the transmission dyno and ready to put in.

NIIIIIIIICE, U-buildem ?

I could not get transmissions to hold together in Freedom US1 46 Skater. You can try them in my boat. If they hold up for a few rough water runs you have a winner. I think the high performance boating community could use something like this. Good Luck!!!

motors look a little familiar :party-smiley-004:

Very nice.

Put a set of those badd Boyz in the Freedom US1 46 Skater for R & D , and Jimmy will test them better then that dyno will ever do ... lookin good :D

Has the case design changed from earlier pictures ?

The input shaft design appears similar to that Borg Warner uses. However, relative to overhung load, bell housing alignment and drive plate durability, should an input shaft nose rod fit a crankshaft pilot bearing ?

Your pictures convey a very sanitary assembly.

Are those attached to buddyoo's big hp diesels???????:evilb:

thats pretty funny.

Looks pretty nice, have any more info to share with us ?


Thanks
Jon