Time to install outdrive. All "O" rings in place. Can't find part # for gasket that keeps water out of driveshaft tube, (snout). This gasket keeps driveshaft bellows free of water. It's been a long 2 years.
Thanks for all the help thus far.
P.T.L. Rory

I'm not sure what gasket you are talking about. The bellows just fits around the transom assembly and is held on with a hose clamp and in the rear it slides into the bell housing and you pound in the ring/sleeve from inside. The drive itself just mates directly against the bell housing and yo u tighten down the 6 bolts

On a bravo ,there is no additional seal at snout .Drive seals against exposed portion of u-joint bellows

Thank You !!