Exhaust Tip question??
04-24-2005 | 10:21 PM
#1
Thread Starter
Registered
Joined: Aug 2003
Posts: 565
Likes: 0
From: Texoma/LOTO
Exhaust Tip question??
I was reading through Nort's video thread and noticed the exhaust tips he has. I was wondering who makes those? I have the same setup, but my tips are flush with the transom with a black flapper instead of the angle cut tips.
04-25-2005 | 05:33 AM
#2
Registered
Joined: Feb 2004
Posts: 4,909
Likes: 9
From: Northeast,Fla
04-25-2005 | 05:38 AM
#3
Registered
Joined: Feb 2004
Posts: 4,909
Likes: 9
From: Northeast,Fla
Re: Exhaust Tip question??
there are several manufactors that make em ..... you might do better by checking with Fred Cecil @ www.trickmarine.net very knowledgable ...Also make sure you get the correct angle ...Ask Outlaw .......
04-25-2005 | 07:18 AM
#4
Registered
Joined: May 2003
Posts: 11,772
Likes: 0
From: In the Mountains
Re: Exhaust Tip question??
My two cents:
Don't waste time. Give Fred a call. Best price and best service on the Planet Earth. Double check if your existing tips have an angle on the flange or are "straight or flat". Mine are flat (no angle), like shown in the above photos and the angled flange WILL NOT work.
And there is NO flapper noise with the Stainless Marine tips.
Don't waste time. Give Fred a call. Best price and best service on the Planet Earth. Double check if your existing tips have an angle on the flange or are "straight or flat". Mine are flat (no angle), like shown in the above photos and the angled flange WILL NOT work.
And there is NO flapper noise with the Stainless Marine tips.
Last edited by Formula Outlaw; 04-25-2005 at 07:24 AM.
