Engine room treadplate
 

Replacing the rubber mat on the step in my engine room with powdercoated aluminum treadplate. Rubber was looking pretty bad. Custom fabricated deal.

Before/after:

Re: Engine room treadplate
 

Before/after:

Re: Engine room treadplate
 

More:

Re: Engine room treadplate
 

Hey, did that save any weight? :)
Thanks,
Garrett

Re: Engine room treadplate
 

Probably about the same weight as the rubber. I used the 1/16" treadbrite which is the same thickness as the rubber mat. It is actually a little flimsy, but it is secured to 3/4" plywood so I don't think it will matter. I would have preferred to use the 1/8" treadplate ... it is pretty stout but it is also a fair bit heavier.

Re: Engine room treadplate
 

Garrett, if you decide to do that, you better show me some pics :drink: :drink:

Looks like it is going to be sweet Chris. I'm ready to see what it looks like installed

Corey

Re: Engine room treadplate
 

Hi Corey,

I'll probably wait a little while on the mod's. I talked to Mike today. Sounds like the boat is running really great. Weather permitting, I'll be driving out to pick it up on the 27th and get the boat on the morning of the 28th. I think. :)

I bet that aluminum tread plate would look good anodized black. But, the powder coat is probably better at resisting corrosion, I'm guessing.

Garrett

Re: Engine room treadplate
 

It's out to the powdercoaters now. I will get a couple shots when I get it re-installed.

Re: Engine room treadplate
 

I don't have to worry about any rubber mats. I don't even have room to drop a wrench :(

Re: Engine room treadplate
 

One day turn-around with my powdercoater: