Re: project ......
 

River Rat probably a good idea...... :( :(

Re: project ......
 

I"m Not Gonna Look ...

Re: project ......
 

OK new plan ... after looking over the situaion .. we drilled a test hole in Starboard stringer ...about 12" from the bulkhead end .... mush ... So on tomorow the plan is to make a template for the motor mounts ...piece of plywood with holes for the inner transom assembly to the front motor mounts. Also going to measure from a straight edge to top of the motor mount brackets ... we're going to try and make a template of the stringers too ..... then cut em all out ... It was going to cost almost 1000.00 for the seacast not counting the outside stringers . I can do it less with plywood. I talked to one of the best shops around here and they said to use Fir plywood instead of marine ....

Re: project ......
 

I'll look at your picture... so I can do mine!

Re: project ......
 

Why did he want Fir over Marine?

Re: project ......
 

he said it "wasn't Pine" ... still has exterior glue ....gona do some more asking ....

Re: project ......
 

Gonna start calling you "Little Jon"....:eek: :D

What a quagmire....:eek: :eek:

Re: project ......
 

His boat is bigger then mine!!!!! :drink: :drink:

Re: project ......
 

I used Okume (not sure of the spelling)

Re: project ......
 

This is were I get my Marine wood. Some info that may help....

http://www.boulterplywood.com/

Just click on the marine plywood.

Jon