Purchased these from Trick. Just finished installing them. Thanks Fred!

:d

Very nice

THANKS! Took a while to figure out where they would fit.

Robert-I was able to get the lube reservoirs relocated too. That was a royal PITA. Should take the pain out of filling them up.

Kevin,

Nice! What did you fasten them to?

On the area where the rubrailis fastened to. I am fabricating a strip of aluminum that will fasten to the existing inside rubrail "washers" for extra strength. I'll bolt them directly over the new aluminum strip and refasten the fender holders to the strip.

I wondered about that having adequate strength. The previous owner of my boat had fastened something to the same area and it looked like it had pulled out.

My drive lube reserviors are mounted in the same place, so I don't think I can copy your idea.