Here's Johnny

Does anyone know where to get those fender holders that are mounted in the bilge, and you just slide the fender in when there not in use? I have seen them on some boats and would be interested in adding some to my boat.

LapseofReason

Most are custom made out of Star board or something similar,Get a big hole saw or jig saw and cut them out. The boat builder may have a template for your boat if they did them on your style boat before but I doubt it.

hugetime1

I had them in my hustler, I would not recommend them, mine broke into little pieces from running the boat hard. and it is a pain to work on the motor with those in there.

Payton

West marine has some Stainless steel ones that you can mount where ever you want. It's like a heavy wire basket. When they are in your way, you simply lift the holder out of it's braket to remove.

JC

I had two custom sets made, but only used one set in my Tiger. I will post a photo this weekend and would sell on set . Mine are made out of alum and I had one mine pwd coated blue the other set is still alum.

Sean H

those are sweet JC..... make sure the lines are tucked in under the fenders though.... that belt might get hungry

dreamer

sold... alluminum is just what my playboy needs

pm me a price

Jassman

If Dreamer doesnt end up getting them, Ill buy the blue one off you, or the Alum ones, thanks, just PM me. Jeff

Quiet Storm

I saw some in a new Cig at the Chicago boat show that looked like they were made from large PVC pipe.

I was going to take a fender to Menards a see what it fit in.

Sean H

8" fender and cover i would say 10" pvc if you can find it...