382 Fastech Engine/ Drive Packages
#11
very close.....my aluminum trailer was over 45 but I was able to cut some of the tongue out of it to get it below 44....a steel trailer could be a little shorter still. The windshield is probably about 9 feet but not over 10.
#15
Registered
Joined: May 2007
Posts: 330
Likes: 0
From: Louisiana
My trailer has drive guard, and is 46' long from tongue to guard, just fits in a 50' building with 4' work bench.
2001 500 efi, xz drives, getting 51 mph @ 3500, 68 mph @4700, need to get props labbed to get to 52-5400 rpm
Love the gen, cabin is at 70 degrees if I can keep it under 40 mph
2001 500 efi, xz drives, getting 51 mph @ 3500, 68 mph @4700, need to get props labbed to get to 52-5400 rpm
Love the gen, cabin is at 70 degrees if I can keep it under 40 mph
#17
I would guess 30's too.....and they are too big!!!! ...but I seem to remember him saying he was spinning 28's.
With my built motors I spin 30's.....3,500 at about 51 GPS, and max of 5,500 rpms in the low 80's.
With my built motors I spin 30's.....3,500 at about 51 GPS, and max of 5,500 rpms in the low 80's.
Thread
Thread Starter
Forum
Replies
Last Post
XtremePowerboats.com
Drives and Lower Units
2
06-24-2008 02:58 AM





