trip 800's 94 419 formula
#1
Registered
Thread Starter
Join Date: Oct 2007
Location: Union, NE
Posts: 468
Likes: 0
Received 0 Likes
on
0 Posts
trip 800's 94 419 formula
I have a friend with a 1994 419 that has put in new power and now is needing info for drive height. It has Imco boxes and he is wanting to now if the boat will handle better with shorties on all 3 drives, he is using 2 standards and 1 short now. Any help would be appreciated.
#3
Registered
iTrader: (2)
Join Date: Aug 2005
Location: Between A Womans Leggs in IL
Posts: 6,306
Likes: 0
Received 1 Like
on
1 Post
fixx
remove all 3,install #6 drives and the other 2 engines in a staggard form..sell all the bravo stuff..will save a ton of money when all the bravo stuff starts to brake after 10hr's of use with the 800 hp engines.
#5
Registered
It's the right answer though.
#6
I was told the center drive if brought up without raising the outside two would cause issues. The mix of props 3 across so close together would raise slip and lose efficiency.
If the outer drives are on extension boxes and raised then it might not be an issue.
The drive height is an issue same as ALL boats. You have to experiment with it and see. Not too many 419's repowered due to not being a fast boat to begin with.
The remove 3 and install #6's. Sounds great. Except the structures, transom, stringers, bulkheads, mounts, toilet, generator, sub floor, everything would have to be gutted and new installed.
I would say the idea of totally redesigning the back 1/2 of the boat is not the type of information the guy is looking for.
If the outer drives are on extension boxes and raised then it might not be an issue.
The drive height is an issue same as ALL boats. You have to experiment with it and see. Not too many 419's repowered due to not being a fast boat to begin with.
The remove 3 and install #6's. Sounds great. Except the structures, transom, stringers, bulkheads, mounts, toilet, generator, sub floor, everything would have to be gutted and new installed.
I would say the idea of totally redesigning the back 1/2 of the boat is not the type of information the guy is looking for.
Last edited by OPIE272; 11-27-2011 at 08:55 AM.
#8
Registered
I doubt the drives are any closer than a fully staggered twin set up.
#9
Registered
Join Date: Feb 2002
Location: Lake Michigan
Posts: 6,627
Likes: 0
Received 0 Likes
on
0 Posts
I would run it as is now to see how it handles. With faster speeds its going to run higher out of the water.
See how the props look if water boil shows up on the center drives blades.
See how the props look if water boil shows up on the center drives blades.
#10
Registered
Thread Starter
Join Date: Oct 2007
Location: Union, NE
Posts: 468
Likes: 0
Received 0 Likes
on
0 Posts