Although they don't fit in the step plates, they make a nice addition to an already really nice dash!

Thanks again to Bill at Diamond Performance! 302-521-0123

I put red anodized in a few years ago when I did the wheel ect, I thought you did too?
Those are a quality lookin piece tho


I hope 5 inch hasn't seen those black bolster switches . . .


and just where is your glovebox lid bump/stop? huh?

I did put the red ones in too, but now with the carbon fiber "red" dash and stainless bezels, I needed a change. They look real nice and they are Billett!

Never had the bump stop? Does it go in the little hole there?

Factory black switches. I was going to change them out, but realized that the newer one are too easy to activate by accident.

Dave

yes little arrow headed push-in

you get use to it. I seldom activate mine by accident but do find them very easy to use as I adjust often-

maybe some flat white Fusion?
The bezel would be no problem, and I feel it would stay on the rocker if prepped, multiple THIN coated and cured proper.