Offshoreonly.com - Anyone change Lens on Bomar hatch

Page 2 of 2

Show 40 post(s) from this thread on one page

Offshoreonly.com (https://www.offshoreonly.com/forums/)

- Formula (https://www.offshoreonly.com/forums/formula-36/)

- - Anyone change Lens on Bomar hatch - mine is cracked (https://www.offshoreonly.com/forums/formula/345086-anyone-change-lens-bomar-hatch-mine-cracked.html)

snowrunner

03-02-2017 08:35 PM

Thanks, its worth a shot.

Quote:

Originally Posted by ren3 (Post 4533770)

Your best solution is to replace the hatch if you can not mechanically fasten the old handle onto the new plexiglass. It is going to be difficult to bond to the plexiglass permanently. Epoxy will not work. Cyanoacrylates will not work for long. You might call Plexus Adhesives for some advice.

axapowell

03-25-2017 01:16 PM

I had to glue the handle back on my hatch a couple years ago. I used SCIGRIP 16 10315 Acrylic Cement, Low-VOC, Medium bodied Clear.

Amazon for like $6.00

Still holding today!

Dave

snowrunner

03-26-2017 11:16 PM

Quote:

Originally Posted by axapowell (Post 4540727)

I had to glue the handle back on my hatch a couple years ago. I used SCIGRIP 16 10315 Acrylic Cement, Low-VOC, Medium bodied Clear.

Amazon for like $6.00

Still holding today!

Dave

I used Loctite Plastic bond when I got the boat. Took a lot of work to remove it, the factory weld took almost a flick of a finger in comparison to remove. If I need a mech attachment later, so be it. Going with the Loctite again.

All times are GMT -5. The time now is 08:56 AM.

Page 2 of 2

Show 40 post(s) from this thread on one page