Please explain
07-09-2018 | 08:42 AM
#1
Thread Starter
Registered
Joined: Oct 2013
Posts: 291
Likes: 4
From: Miami, FL
Please explain
I am new to my 312 fastech. Wondering what i am doing wrong? This has happen twice already, when taking off normal I notice or it feels like the boat will roll over. Both times I come off throttle and and it then corrects itself, then I proceed to take off again and it is fine.
Are drives too high? Should the tabs be down on take off etc?
Will these boats roll over?
Again this is normal take off.
thanks
Are drives too high? Should the tabs be down on take off etc?
Will these boats roll over?
Again this is normal take off.
thanks
07-09-2018 | 12:45 PM
#7
Platinum Member
Joined: May 2012
Posts: 11,427
Likes: 3,953
From: Midwest & T-Rock
LOL..............^^^^^.....next time leave the tabs neutral and just use the drive trim, you may have one drive trimming up and the other staying tucked, are there two separate switches for the drive trim or a single on the throttle ?
07-09-2018 | 02:22 PM
#8
Thread Starter
Registered
Joined: Oct 2013
Posts: 291
Likes: 4
From: Miami, FL
Yes roll over port to starboard.
Yes two separate switch and one on the throttle to control both at the same time. Also going to adjust tabs and drives to be even with hull at around 5/6 on trim indicator or shouldn’t it be set to some other number.
is that what you mean ?
Yes two separate switch and one on the throttle to control both at the same time. Also going to adjust tabs and drives to be even with hull at around 5/6 on trim indicator or shouldn’t it be set to some other number.
is that what you mean ?
Last edited by Priobe; 07-09-2018 at 02:27 PM.
07-09-2018 | 02:39 PM
#10
Banned
Joined: Jul 2011
Posts: 9,594
Likes: 45
From: Ft. Worth TX
