1988 242 LS Brought her home
#21
Thread Starter
Registered
Joined: Jun 2021
Posts: 175
Likes: 124
From: Raleigh, NC
Figured I'd add some pictures since I had some time to get out and open it up. Pulled out all the gear from the previous owner so I can sort through and organize.
Trim tabs working fine now zero issue. Trim indicator working but seems a bit off... Might pull it apart and clean or service it.
Need to chase a few electrical gremlins with the stereo and horn but overall seems great!





Plenty of elbow grease and polishing ahead in my future, lucky the boat isn't far from the patio where I can keep the smoker going and work on the boat at the same time 😂.
Trim tabs working fine now zero issue. Trim indicator working but seems a bit off... Might pull it apart and clean or service it.
Need to chase a few electrical gremlins with the stereo and horn but overall seems great!





Plenty of elbow grease and polishing ahead in my future, lucky the boat isn't far from the patio where I can keep the smoker going and work on the boat at the same time 😂.
#22
Registered

Joined: Nov 2020
Posts: 131
Likes: 160
From: Grand Haven MI
Looks nice CW. On the pic straight on from the front I see a cap and vent just on the starboard side of boat. My 89’ doesn’t have that. Is that for a pump out head? Or fresh water fill for sink? My porta Potts just pulls out to empty and I never looked to see if I had the freshwater tank for my little sink. I am assuming your fuel cap/vent is back just in front of engine on starboard side where mine is. I was just wondering when I saw it.
#24
Thread Starter
Registered
Joined: Jun 2021
Posts: 175
Likes: 124
From: Raleigh, NC
Looks nice CW. On the pic straight on from the front I see a cap and vent just on the starboard side of boat. My 89’ doesn’t have that. Is that for a pump out head? Or fresh water fill for sink? My porta Potts just pulls out to empty and I never looked to see if I had the freshwater tank for my little sink. I am assuming your fuel cap/vent is back just in front of engine on starboard side where mine is. I was just wondering when I saw it.
Yessir, it's labeled waste so assuming for the pump out head.



