Wadda ya think? My home made battery covers......
 

Finally got around to writing a program to engrave the logo.

I can either do the full logo, just 'FOUNTAIN' or just the circle. I'm going to have so much Fountain logo chit on my boat and dock, there will be no misunderstanding what brand I own. Might even try to tattoo the wifes azz. :evilb:

The battery covers are my 1st finished project.
I did go back over them with 2500 sand paper to remove the finger prints then cleared them after this pic was taken. I have 2" stand offs that are screwed to the battery top frames that these covers bolt too to clear the cables and battery post.


The clear plexy was my 1st test run that had a couple goofs from my editing that I corrected in the final program.

If you shine a light thru the outter edges, only the logo lights up. Going to make a frame with LEDS to light'r up.

Circle only. Kinda hard to see with the brown background.

Very Nice !!!!

Great job..looks fantastic..

very nice, make me a pair in blue!

Looks great I would like some also.

Great Job! ! !

Sweet!!

how much for a pair in purple????

how much to see your wifes azz...........????:D:D:cool-smiley-027:

coool... how much for a pair in blue as well? Do you have your own equipment or is this done at work, on the side?




it sounds like that could be a lot more than the battery covers:D

Very nice job on the battery covers, you going to market them? I'd be in for a pair.