Wadda ya think? My home made battery covers......
02-23-2008 | 12:23 PM
#1
Thread Starter
Ginger or Mary Ann?
Joined: Oct 2000
Posts: 11,030
Likes: 9
From: L
Wadda ya think? My home made battery covers......
Finally got around to writing a program to engrave the logo.
I can either do the full logo, just 'FOUNTAIN' or just the circle. I'm going to have so much Fountain logo chit on my boat and dock, there will be no misunderstanding what brand I own. Might even try to tattoo the wifes azz.
The battery covers are my 1st finished project.
I did go back over them with 2500 sand paper to remove the finger prints then cleared them after this pic was taken. I have 2" stand offs that are screwed to the battery top frames that these covers bolt too to clear the cables and battery post.
The clear plexy was my 1st test run that had a couple goofs from my editing that I corrected in the final program.
If you shine a light thru the outter edges, only the logo lights up. Going to make a frame with LEDS to light'r up.
Circle only. Kinda hard to see with the brown background.
I can either do the full logo, just 'FOUNTAIN' or just the circle. I'm going to have so much Fountain logo chit on my boat and dock, there will be no misunderstanding what brand I own. Might even try to tattoo the wifes azz.
The battery covers are my 1st finished project.
I did go back over them with 2500 sand paper to remove the finger prints then cleared them after this pic was taken. I have 2" stand offs that are screwed to the battery top frames that these covers bolt too to clear the cables and battery post.
The clear plexy was my 1st test run that had a couple goofs from my editing that I corrected in the final program.
If you shine a light thru the outter edges, only the logo lights up. Going to make a frame with LEDS to light'r up.
Circle only. Kinda hard to see with the brown background.
Last edited by US1 Fountain; 12-02-2011 at 11:13 AM.
02-23-2008 | 02:50 PM
#4
Charter Member
Joined: Mar 2001
Posts: 744
Likes: 3
From: MONTGOMERY,AL
02-23-2008 | 07:54 PM
#9
Registered
Joined: Aug 2005
Posts: 2,544
Likes: 0
From: Hopkinsville, Ky
02-23-2008 | 08:07 PM
#10
Registered
Joined: Jan 2004
Posts: 5,325
Likes: 112
From: Northern NY
Finally got around to writing a program to engrave the logo.
I can either do the full logo, just 'FOUNTAIN' or just the circle. I'm going to have so much Fountain logo chit on my boat and dock, there will be no misunderstanding what brand I own. Might even try to tattoo the wifes azz.
I can either do the full logo, just 'FOUNTAIN' or just the circle. I'm going to have so much Fountain logo chit on my boat and dock, there will be no misunderstanding what brand I own. Might even try to tattoo the wifes azz.
Very nice job on the battery covers, you going to market them? I'd be in for a pair.
