No wave effect. Just butt them together. Looks mechanical.

$70 a ft 70' $490 just for materialInsert looks nice with the white I must say

it looks good , I would like to see pics of the rub rail on the beak , I think I would like to do mine . thanks Tim

ttt

Have not got around to doing beak yet. Can't find any close ups of other boats. We are 4 months from boating here. So I will get back to it after holidays. Same as rear corners. I just but the first piece up to Fountain center piece in the middle rear and screw the piece to the rub rail. Then I use a rubber mallet and slowly bend it around. Takes patience but is well worth it.

can't wait to see the pics , it does look good . what does the stainless cost , and where do you get it for the good price ? thanks Tim

rubrails.com. $300 ish. Delivered.

Hey guys - bumping this one back to the top as I'm considering adding the SS insert over my white insert after talking with Al at rubrails.com. For those of you who have done this, how has it held up over time? I'm a little concerned about screws working themselves out or becoming stripped out since they're just going into the hard vinyl.

Appreciate any feedback!

old thread,,any pictures from top down?

double post