bolster seat problem
#1
Thread Starter
Registered
Joined: Jul 2003
Posts: 24
Likes: 0
My bolster seats were working fine before i put my 1995 27 fever away for the winter.Now comes spring and there is no power at all.I checked the fuses under the dash and the circuit breakers.Any suggestions would be greatly appreciated.
#5
Registered
Joined: Dec 2010
Posts: 523
Likes: 0
From: Port Deposit Md
If fuses haven't shown anything put a meter on the connections from the seat auger motor and work your way back. Sooner or later you will find the break in power. I hate electrical problems. Good Luck
#6
Registered User
Joined: Mar 2012
Posts: 420
Likes: 0
From: Baltimore md
Luckily there shouldn't be to much in that curcuit, the fast both bolster are not working lead me to believe its and open fuse or breaker. Meter the fuse for continuety.... I've had fuses open that looked fine.
#7
Registered
Joined: Jun 2011
Posts: 2,347
Likes: 4
From: Thousand Islands area
check all connections, sand them down and diaelectric grease. Follow all the wire to make sure there isnt any breaks. If not might need a new pump, quick fix but new pumps are like 400 bucks.
Mine wasnt working either ended up being a leak in the resovoir, replaced and that works fine. I didnt even know it was leaking all the fluid would drain into the lower bilge because of how the boat sits and then just went out when I open the hole. Never knew it was leaking.
Mine wasnt working either ended up being a leak in the resovoir, replaced and that works fine. I didnt even know it was leaking all the fluid would drain into the lower bilge because of how the boat sits and then just went out when I open the hole. Never knew it was leaking.



