|
The new pipes are 4" also ?
|
Yes, EMI 4" dry to the tip.
|
Originally Posted by glen george
(Post 3916240)
1/2 way there. I have all next week off.
|
Will your hatch close? Looks close, unless your hatch has the insert
|
1 Attachment(s)
I was concerned. There is a 1/2" clearence from the top of the pipes. I don't think the stock hp500 air cleaners would have fit. I had to raise up the exhaust holes 1".
|
2 Attachment(s)
I ended up installing stainless turn downs,,$200.00 for all four,they are actually Diesel truck tips,,I finally put the boat in the water yesterday,it took 90% of the vibration away,,you can see by the picture below how now the exhaust exits out from under the swim platform ..as you can tell the water is very high so lakes are shut down,,I think all the vibration will be gone once in gear and the boat is moving
|
Originally Posted by boatnt
(Post 3916603)
I ended up installing stainless turn downs,,$200.00 for all four,they are actually Diesel truck tips,,I finally put the boat in the water yesterday,it took 90% of the vibration away,,you can see by the picture below how now the exhaust exits out from under the swim platform ..as you can tell the water is very high so lakes are shut down,,I think all the vibration will be gone once in gear and the boat is moving
|
Originally Posted by 575cat
(Post 3916635)
Wow that bugger sits low .
|
1 Attachment(s)
I relocated my batterys forward into the side compartments, removed the silent choice and other parts. Hoping to raise mine up a little. I will post new pictures soon.
|
More expensive than the rubber but could look decent with a polish or a scotch brite satin.
http://www.ebay.com/itm/4-stainless-...80a38a&vxp=mtr |
| All times are GMT -5. The time now is 08:07 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.