Is there a bolster repair how-to?
02-23-2013 | 07:23 AM
#1
Thread Starter
Registered
Joined: Mar 2005
Posts: 1,266
Likes: 0
From: Mine Hill, NJ/Lake Hopatcong, NJ
Is there a bolster repair how-to?
Going to take mine apart today to replace seat bottoms as well as reshaping/welding the frame. I'm sure it's been done many times but was curious if its been documented.
Any pointers are welcome.
Any pointers are welcome.
02-23-2013 | 11:05 AM
#2
Ginger or Mary Ann?
Joined: Oct 2000
Posts: 11,030
Likes: 9
From: L
I reinforced mine heavily... top frame member, new bracing rods, redesigned the seat bottom pivot mounts, cyl pivoting plates
Just gotta look at whats bent and whet flexes when you apply weight to the seat bottom, and then see what needs to be done to straighten and reinforce it all. Before the mods, my seats were short of fully raising up. Afterwards, they come up fully and are strong enough to lift the boat up by them.
Just gotta look at whats bent and whet flexes when you apply weight to the seat bottom, and then see what needs to be done to straighten and reinforce it all. Before the mods, my seats were short of fully raising up. Afterwards, they come up fully and are strong enough to lift the boat up by them.
__________________
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
Some people are like Slinkies - Not really good for anything, but they
bring a smile to your face when pushed down the stairs.
