Lunatic Fringe

Steve's stagger will provide a little bit of a challenge for down spouts. The starboard, inboard pipe, comes out right over the port transom housing.

ApachePete

What an ODD configuration!

Lunatic Fringe

Gary,
What is the drop from muffler centerline to the end of the down pipe on the ones you have for sale? I may be interested in those for my Cougar, or modifying my Gaffrigs in a similar manner.

Jim

RMPRam

iTrader: (1)

The dimension from the center of the muffler to the tip of the "down-tube" is 18"
Do you need any other dimensions?

RMPRam

iTrader: (1)

I just looked @ the transom on your Apache.
I believe it would be possible to take the 2 port pipes and "drop" the "down-tubes" to the left of the port drive and take the 2 stbd. pipes and "drop" them to the right of the stbd. drive.
The ex. pipe between the drives would probably have to have the horizontal run of the "down-tube" lengthened a few inches to clear the gimble.
It can be done.
Give me a call and we could discuss it.

Gary Kollofski
ph: 763-473-8963

offshoredrillin

lol, yea who built that thing anyhow?

Ratickle

What type of switchables do you have on there now? Did they test with them in the "silent" position? Also, before you spend a bunch, it looks like the law will change, within the next two years max, to where we will also be tested at speed in Michigan (similar to Wisconsin's law), not just at idle.

Nykamp

I am going with the new CMI's 5 by 6's from Fred @ Trick, Thanks Fred. Steve

BeakBoater35

What are "new CMI's 5 by 6's"? Why did you decide on them? I'm looking for mufflers for Mercury HP525SC motors. Appreciate your thoughts.

Too Old

My pleasure Steve. Glad I was able to help.