GPS with video inputs

Reply Subscribe

Thread Tools

05-31-2007 | 06:38 PM

#21

BenPerfected

Platinum Member

Joined: Dec 2002

Posts: 2,195

Likes: 2

From: Dallas, TX

More Ray Marine CAM50 info:

http://www.raymarine.com/raymarine/a...9429&type=news

http://www.anchorexpress.com/product...amera_-_E03016

05-31-2007 | 07:39 PM

#22

tanner

Registered

Joined: Jul 2006

Posts: 886

Likes: 0

From: Ft. Lauderdale Florida & Tarpon Springs Florida

Quote:

Originally Posted by BenPerfected

Has anybody tried the new Ray Marine CAM50 camera? I just found this online for less than $200. It seems like this compact unit could be the low cost camera for below deck or the engine compartment.
Is there any reason this camera wouldn't work in any GPS with the NTSC connection? Where can you get a 30' video cable?

You can use Cat 5 with vellums attached to the ends for connection

06-02-2007 | 01:55 PM

#23

ACTIVESHACK

VIP Member

Joined: Mar 2006

Posts: 3,203

Likes: 1

From: Aspen, CO

Here's a few pics. for you Gino.

Attached Thumbnails

06-02-2007 | 03:23 PM

#24

LubeJobs42

Thread Starter

Registered

Joined: May 2002

Posts: 3,600

Likes: 8

From: Fort Lauderdale

Quote:

Originally Posted by ACTIVESHACK

Here's a few pics. for you Gino.

That is friggen beatiful. Unfortunatly the dash in the new mti can't accomadate anything even close to that! I would have to remove every gauge on the port side to make that work. If I was startig from scratch that would be the way to go. Can the northstar gauge mode work with any engines or just the Mercs with smart craft?

06-02-2007 | 06:02 PM

#25

ACTIVESHACK

VIP Member

Joined: Mar 2006

Posts: 3,203

Likes: 1

From: Aspen, CO

Quote:

Originally Posted by LubeJobs42

Thanks for the compliment

Mine is the 12" model but they make a 6.5" 8.5" 10.5" 12" and a 15". I think it will only work with the Merc. setup. When i built the boat Pat had to order twin wiring harnesses on each motor to set it all up.