As a matter of fact I do....:cool-smiley-027:

These are the specs I mailed to Extreme and it fit like a glove. Yours should be the same except for your tabs. I don't know if the are the same brand and location.



Exhaust Pipe Diam: 4 Inch
Exhaust Flange Diam: 1 Inch
Type of Drive: Mercruiser Bravo 1
Transom Angle: ??
External Steering: Mayfair Single Ram
Lifting Eyes: 2, See Picture

A: Width of Transom at Top, 73.25 inches
B: Center to center, 27.5 inches
F: Rub rail to keel, 17.5 inches
H: Bottom of rub rail to center, 2.5 inches
I: Bottom of rub rail to gimbal, 5.5 inches
J: width of transom at bottom 69 inches

U: 15 inches
V: 20.25 inches
W: 26.75 inches

X: 10 inches
Y: 12 inches
Z: 15 inches

Color Choice: RAL 3001

Thanks Dave!

Thanks for the suggestions I will check them out.

I remember that thread over on MWBP too, looked really nice and affordable...I just paid twice what you were quoted for a sweet billet piece, but it was a specific custom one and knew it would cost more....damn where's Wiggler when ya need him, he probably has a cheap CNC machine just lying around and could make them for $500.00...:cool-smiley-027:

Jim Kruse Powdercoating at LOTO made mine last Fall. It was $1600 installed. He will most likely need the boat to make it unless you can use one of teh standard versions he has a jig for.
http://www.offshoreonly.com/forums/s...d.php?t=181516

this one was 2500. as an option from Nortech, I had it painted to match and non skid applied as well...best and safest thing Ive ever done on a boat. It covers the drives completely and makes it easier boarding, one step up to the fiberglass step and then one more to sunpad..Good Luck Jeff

Do you have more pics of yours to post Griff? The pic on the other thread doesn't show it very well.

Thanks!