i need some HELP{cobra terminator 3000}
#13
Registered
Join Date: Feb 2010
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
i used to work 4 cobra in th 90's we set up the race & pleasure boats w/ 2 outboards w/ short shafts you want the nose cone to ride an inch to an in & 1/2 above the 4 inch pad it runs behind off of the hull we had the engines in on brackets that stepped them off the transom about 10 inches if you want to add the center motor it would need to be a long shaft i think i am not 2 sure what the sweet spot is 4 the rigging the power head did sit a little higher w/ all three motors in line on the transom when i worked thier i did more work w/ the pleasure 30 ft w/ the blackhawk drive good luck
#14
Gold Member
Gold Member
#15
Banned
Thread
Thread Starter
Forum
Replies
Last Post
kevinlafleur
General Boating Discussion
4
08-30-2004 07:42 PM