RPM 26 Redline/Teague 800 - Video
04-18-2011 | 01:49 PM
#23
Registered
Joined: Mar 2004
Posts: 2,696
Likes: 93
From: Pa
It has a lot to do with the hull design. Our bottom is significantly different then anything else out there in the 22-30' size range and even most of the bigger cats. We did not "copy" anybody's bottom design. Instead we went with a complete CAD/5-axis plug which enabled us to do things differently with compression and aero lift. We have also learned a few things in the past year with regards to setup and CG that allowed us to pick up more speed over what we were already able to do.
04-18-2011 | 09:18 PM
#26
Thread Starter
Registered
Joined: Sep 2002
Posts: 73
Likes: 0
From: Harpersville, AL
I wanted to say thanks for all of the compliments. We are very committed to constantly improving.
We are just about to start cutting and seaming. Just finished the modeling stage and feel like we have a design that will work well. Want one??
We are just about to start cutting and seaming. Just finished the modeling stage and feel like we have a design that will work well. Want one??
04-19-2011 | 05:52 AM
#29
Platinum Member
Joined: Jan 2009
Posts: 3,511
Likes: 24
From: Springfield, Louisiana
04-19-2011 | 10:58 AM
#30
Offshoreonly Advertiser
Joined: Mar 2005
Posts: 817
Likes: 3
From: Valencia, CA
Hey Steve,
I have seen the video about 10 times now and I am still amazed. The project turned out so clean and simple! I look forward to doing more engine packages in the future! We have a great combo going here!
P.S. Don't you think you could tidy things up a bit cleaner in the bilge? hahaha....
Eric
I have seen the video about 10 times now and I am still amazed. The project turned out so clean and simple! I look forward to doing more engine packages in the future! We have a great combo going here!
P.S. Don't you think you could tidy things up a bit cleaner in the bilge? hahaha....
Eric
