29 kryptonite speed/setup questions
#1
Registered
Thread Starter
Join Date: Oct 2007
Location: Long Island, NY
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
29 kryptonite speed/setup questions
hey everyone i have a 29' kryptonite with a 650hp 548 bravo xr with the stock dwp lower and bravo 1 28P with some pitch added.
it runs the best of 93.8 at 6000 rpm light on fuel and usually runs 90-92 at 5800-5900 with more people and fuel.
you guys think id benefit with an imco lower.. possible shorty and or a different type of prop? hydromotive etc.
thanks!
it runs the best of 93.8 at 6000 rpm light on fuel and usually runs 90-92 at 5800-5900 with more people and fuel.
you guys think id benefit with an imco lower.. possible shorty and or a different type of prop? hydromotive etc.
thanks!
#4
Registered
Thread Starter
Join Date: Oct 2007
Location: Long Island, NY
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
no ITS.. ill check to see where my prop shaft centerline is after work. id like to do something to get a little more out of it but id hate to do a lower and get no results.
what prop type are you guys running? think id do better moving away from the bravo 1?
what prop type are you guys running? think id do better moving away from the bravo 1?
#5
Registered
What ever Fast Fun 2 tells you should be Golden, I believe they have one and have wrang out every last bit of speed from it (Thats what they do )
But, if the 29 Fountain ( Watch Your Back) and the new 29 Outerlimits are any indication of how high your X dim can be I'm sure you still have room to go up, They are very high and achive Great speed, Both have Shorties.
But, if the 29 Fountain ( Watch Your Back) and the new 29 Outerlimits are any indication of how high your X dim can be I'm sure you still have room to go up, They are very high and achive Great speed, Both have Shorties.
#8
Registered
Thread Starter
Join Date: Oct 2007
Location: Long Island, NY
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
#9
Registered
Join Date: Oct 2005
Location: LI, New York
Posts: 1,491
Likes: 0
Received 0 Likes
on
0 Posts
Order a case (new or used) from imco and cut the drive shaft. Call skip (or ronnie) and he'll take care of ya. If I remember it wasn't too bad of a price. I almost did towards mid summer until I had to replace the gimbal.
#10
Registered
Thread Starter
Join Date: Oct 2007
Location: Long Island, NY
Posts: 160
Likes: 0
Received 0 Likes
on
0 Posts
ah gotcha i just have to figure out if 2" below the bottom is too high without having a stand off box. i hate that im a speed junkie!