|
I have the stock thermostat housing off my HP 500 if you can use it it's yours .
|
This is what I need I guess to match the other engine. I think the bottom is a 87110 and I know for sure the coever has 47440 on it
http://i25.photobucket.com/albums/c6...a/bb31510e.jpg |
Originally Posted by inthetundra
(Post 3740660)
This is what I need I guess to match the other engine. I think the bottom is a 87110 and I know for sure the coever has 47440 on it
http://i25.photobucket.com/albums/c6...a/bb31510e.jpg |
Very cool gesture, I sent you a PM.
Thanks again, Art |
fixx
Originally Posted by inthetundra
(Post 3740626)
It may not look as fancy as what some of the other boats have, but it's in my garage and will be all cleaned up before going in. I just need to find the right thermostat housing now that I got rid of the heat exchanger. This is farther than I expected to be this year.
http://i25.photobucket.com/albums/c6...a/62f0cd2e.jpg http://i25.photobucket.com/albums/c6...a/b0647ba7.jpg |
Did they come with a squarebore or spreadbore intake ? Carb was changed for sure . Maybe so was the intake . We need to investigate .
|
fixx
Originally Posted by the deep
(Post 3740709)
Did they come with a squarebore or spreadbore intake ? Carb was changed for sure . Maybe so was the intake . We need to investigate .
|
if you are going to use it anyway your going to be making a left or right while trying to plane off.. I knew the carb was changed to an Edelbrock carb The original engine intake is aluminum, this one is cast. Original engine was rated at 330hp. I was told this one was rated at 330 hp at the crank Many new parts, the following components all have less than 300 hrs of use: Cylinder heads done by reputable local machine shop Performance cam & timing gear by same shop Closed cooling pump Rebuilt raw water pump Fuel pump Heat exchanger All belts & hoses Edelbrock carbeuretor Engine wiring harness w/ 10 pin connector Ignition coil, distributor cap, plug wires Platinum plugs Alternator Starter |
If the boat floats and goes and I am happy...I can always find a matched pair over the winter to drop in!
|
fixx
Originally Posted by inthetundra
(Post 3740725)
If the boat floats and goes and I am happy...I can always find a matched pair over the winter to drop in!
a mag is 365 hp and the one you bought is 330 + what ever the old owner did to it..a mag you can rev to 5k a 30 4600 rpm's,a mag has forged internals and 7/16 rods the 330 has cast internals and 3/8 rods.. hope it all works out.. goin to bed see ya! |
| All times are GMT -5. The time now is 07:06 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.