575Sci Owners
#1
575Sci Owners
As most of us know the weak link are the 256 Weiand blowers on these motors. If something goes wrong with the blower there are no hard parts available. I found a company that takes the time to get their blowers to work with the 575Sci setup. Dyers Blowers makes their own cases and rotors. They took my TBI plates and resized the holes to fit their 8-71’s They also took my thermostat housing and machined an adaptor so it also could be used. They also machined a new lower pulley so I could use the serpentine belt setup. I will be running the 8-71’s 5% over for 6-7pounds of boost. I will start the installation tomorrow and I will post photos. So glad to find someone so helpful as Gary and his son Bill.
http://www.dyersblowers.com/
http://www.dyersblowers.com/
#7
Registered
iTrader: (1)
The lower Pulley (like the one they machined for you) is available from The Blower Shop (steel). Tstat adapter is available from whipple and the Throttle body adapter was a direct bolt on for me. I am about where you are at as far as over-driving and am at about 9.5psi on my stripped littlefield 871.
Last edited by JRider; 08-25-2012 at 08:26 AM.
#8
Registered
Knot trying to jack up your thread ... Looks like you have a killer set up going. I have the Blower shop set up. 6-7 pounds of boost. And the support has been great. I have the Arizona Speed set up and I really like it. The stock merc fuel injection has been awesume so far.
Chad
Chad
#9
Registered
Knot trying to jack up your thread ... Looks like you have a killer set up going. I have the Blower shop set up. 6-7 pounds of boost. And the support has been great. I have the Arizona Speed set up and I really like it. The stock merc fuel injection has been awesume so far.
Chad
Chad
Thanks Chad