Offshoreonly.com

Offshoreonly.com (https://www.offshoreonly.com/forums/)
-   General Boating Discussion (https://www.offshoreonly.com/forums/general-boating-discussion-51/)
-   -   How much to replace rear main? (https://www.offshoreonly.com/forums/general-boating-discussion/317506-how-much-replace-rear-main.html)

nova26 09-01-2014 10:02 PM

How much to replace rear main?
 
Twin 5.7 mag P-29 I guessing that where my oil leak is coming from the port rear main. What should I be looking to pay to have the engine pulled and have it fixed and put back in?

nova26 09-01-2014 10:12 PM

1 Attachment(s)
[ATTACH=CONFIG]528675[/ATTACH]Its tight..

Jonesyfxr 09-02-2014 12:04 PM

First try to snug the pan bolts. Over numerous heat cycles they tend to loosen up.

Good luck!!

nova26 09-02-2014 03:14 PM

It takes about 4 weeks to leak out 4 quarts and then the leaking seams to stop. Can the pan bolts be reached without pulling the engine?

4bus 09-02-2014 03:56 PM


Originally Posted by nova26 (Post 4181786)
Can the pan bolts be reached without pulling the engine?

Sure, just cut the back seat out :D

Personally I would have the engine pulled, smoke tested, and all gaskets replaced. My guess is $800-$1400 complete

nova26 09-02-2014 04:01 PM


Originally Posted by 4bus (Post 4181806)
Sure, just cut the back seat out :D

Personally I would have the engine pulled, smoke tested, and all gaskets replaced. My guess is $800-$1400 complete

What's a smoke test?:confused:

1 MAIDEN AMERICA 09-02-2014 04:45 PM


Originally Posted by nova26 (Post 4181786)
It takes about 4 weeks to leak out 4 quarts and then the leaking seams to stop. Can the pan bolts be reached without pulling the engine?

If it leaks while sitting, it's not likely the rear main. There isn't 4 quarts above it to leak out. Look at where the dipstick goes into the pan/drain plug/any other pan fittings.

Smoke test-A machine that burns mineral oil? and pumps the smoke into the crankcase, basically, usually used in the intake to detect vacuum leaks.

4bus 09-02-2014 05:33 PM


Originally Posted by 1 MAIDEN AMERICA (Post 4181828)
If it leaks while sitting, it's not likely the rear main. There isn't 4 quarts above it to leak out. Look at where the dipstick goes into the pan/drain plug/any other pan fittings.

Smoke test-A machine that burns mineral oil? and pumps the smoke into the crankcase, basically, usually used in the intake to detect vacuum leaks.

Yup and yup!

A smoke machine can be used to test anything that shouldn't leak.

For you engine, drain the oil, next place the smoke in the dip stick tube, let it run til u see smoke from the breather, then plug breather. The leak will be the next thing to show a smoke trail

FIXX 09-02-2014 05:51 PM

my smoker has a ultra violet dye in it so you can pin point the leak with a black light..you can also just but the uv oil dye from napa and use a black light to pin point the leak,,you might have a loose drain plug..yes they are still have drain plugs in the pan! ..

Could also be leaking from the oil filter adaptors..

SB 09-02-2014 06:22 PM


Originally Posted by nova26 (Post 4181786)
It takes about 4 weeks to leak out 4 quarts and then the leaking seams to stop.

Is it because it only holds 4 quarts ?





Sorry. Tough long sweaty day at work. A little punchy.


All times are GMT -5. The time now is 02:47 PM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.