Arneson on A single engine cat?
#1
Registered
Thread Starter
Arneson on A single engine cat?
I hear the Arnson Serface drive will work on a single engine 27' cat. I also keep hearing it will not work. Anybody have a single engine cat, especially an Eliminator Daytona or Speedster with this drive?
#2
Registered
iTrader: (5)
Offshore surface style propellers and skegs go thru the water similarly no matter what brand.......so there's no reason why it "won't work".
Lots of single engine cats and V's swinging offshore cleaver props on Arneson, #6, M8, and INDY drives.
Might as well gain the strength, reliability, speed and value of the Arneson!
I hope you gain some helpful knowledge on exact setup! If not I look forward to hearing about your experience!
Lots of single engine cats and V's swinging offshore cleaver props on Arneson, #6, M8, and INDY drives.
Might as well gain the strength, reliability, speed and value of the Arneson!
I hope you gain some helpful knowledge on exact setup! If not I look forward to hearing about your experience!
#6
Charter Member
Charter Member
I hear on a 25 Talon the #7M runs awesome..... Hopefully Rik will chime in... Some say the trick is to run a Chopper prop instead of a cleaver. Been thinking about doing the conversion myself, just got to find the time to research it.
__________________
Everything is for sale @ a certain $$
Everything is for sale @ a certain $$
Last edited by Dean Ferry; 05-18-2015 at 08:19 AM.
#10
Registered
Join Date: Aug 2004
Location: AZ
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
There have been a few different single engine cats with arnesons. I do believe there was a certain 26 that put up some big numbers, however during testing in a turn it got up on the prop and spun in the turn. I don't remember all the details this was a while back.
#6 is going to be your best bet.
#6 is going to be your best bet.