Which scanner?
#1
Registered
Thread Starter
Which scanner?
http://www.rinda.com/acro/prodlist.pdf
Above link, only will use on engine below, what is best for me?
05 496HO, Borrowed one last week did not find a code, was getting single beep over 4500 RPM then constant if I stayed in it. Now getting two beeps but not the every minute recurring, goes away if I lower RPM. I can not tell which engine it is, gut is telling me its the water pressure sensor but want to prove it. I have WP, not hot, and good oil pressure. thanks
Above link, only will use on engine below, what is best for me?
05 496HO, Borrowed one last week did not find a code, was getting single beep over 4500 RPM then constant if I stayed in it. Now getting two beeps but not the every minute recurring, goes away if I lower RPM. I can not tell which engine it is, gut is telling me its the water pressure sensor but want to prove it. I have WP, not hot, and good oil pressure. thanks
Last edited by Expensive Date; 08-23-2015 at 08:57 PM.
#2
Registered
Join Date: Feb 2008
Location: Richmond, Virginia
Posts: 694
Likes: 0
Received 0 Likes
on
0 Posts
It seems like everyone is going with this new one that has multilines for easier reading. Assuming it's a hand held your preferring.
http://www.rinda.com/techmatepro/
http://www.rinda.com/techmatepro/
#4
Registered
Thread Starter
Great tool, hooked it up Sat. No codes, but found a high water pressure event in freeze frame data. Traced it to some grass in the power steering cooler, water pressure is fine now. Ran at WOT for 5 miles no alarms.